Casting FAQ

Yes, we can provide solutions for many challenging, “problem” parts. In fact, investment castings is often the only answer to casting difficult parts economically. Let us know what your challenge is, and we’ll help you find the right solution.

±.005 per linear inch. Angular tolerance is ±1/2 degree. Typical finish is 120 RMS.
Is there an advantage to using investment casting for replacement parts?
Yes, cast replacement parts made from higher tensile alloys cost less and last longer, reducing your downtime for lost parts.
Yes, cast replacement parts made from higher tensile alloys cost less and last longer, reducing your downtime for lost parts.
Yes. Our precision casting process allows us to manufacture intricate shapes that would be impractical or impossible to produce by conventional means. We produce complex parts with fine detail in one piece to 120 rms surface finishes.

 QDOS can cast all stainless steels, and a variety of other materials.

300 and 400 series
17-4 Ph
15-5 Ph
Tool steels
High carbon and low carbon steels
Super alloys
Nickel base alloys
We can also use special alloys made to your specifications. In addition, certified chemical and physical analysis are furnished when necessary, as well as NDT.

We have the flexibility to handle both large and small production runs. QDOS Casting prides itself in meeting your specific requirements and deadlines.

You can learn all about the Investment Casting Process by visiting our investment casting process page.
Investment Casting provides you with incredible design flexibility and reduced costs. Learn more by visiting the investment casting benefits page.

QDOS specializes in both large and small castings – from intricate, miniature parts that are 1/10 of an ounce or less to large investment castings of up to 50 pounds.

Investment casting is an industrial metal forming process used to create wax models, then the models are replaced with melted metals. Firearm components, oil & gas components, medical parts, and more utilize the investment casting process.

The lost wax process is using a wax model and pouring molten metal into the mold. After, the wax model is melted and drained away.
Most metals that can be melted and poured can be used for investment casting. The most common metals are stainless steel, nickel-based steel, cobalt-based alloys, brass, bronze, and copper.
Sand and investment casting have similar processes, but sand casting cannot always make small, intricate parts. Sand casting also often utilizes heavier weight limits, sometimes greater than a ton.
Generally, investment casting has an extensive labor and cost associated with the wax molds, which cause higher costs than forged parts or sand casting.